The Heavy Hitch Bucket Tooth Bar is the heavy duty tool you need to increase your bucket capacity and improve digging performance. TheÂ clamp-on tooth bar is universally compatibleÂ and installs simply with 5/8Ã¢ÂÂ³ set screws in each tooth shank. All you need is a 5/16Ã¢ÂÂ² Allen wrench to install.
Compatible with several front end loader, skid steer and tractor models including (but not limited to):
49Ã¢ÂÂ, 53Ã¢ÂÂ and 61Ã¢ÂÂ buckets on John Deere models 45, 120R, H120, D120, H130, D160, H160, H165, 200CX and 300CX front end loader buckets.
57Ã¢ÂÂ bucket on John Deere 220R model loaders with standard or heavy duty material bucket.
46Ã¢ÂÂ on Kubota LA243 series loaders with 46.5Ã¢ÂÂ standard material bucket.
Be confident in the quality and longevity of our products Ã¢ÂÂ we use only American made steel andÂ qualifiedÂ welders.
HEAVY HITCH BUCKET TOOTH BAR DETAILS:
Universally compatible with all regular buckets (cutting bar size 1/2" or less).
Features heavy duty Pengo 230 shanks (with Ã¢Â
Â inch cup-point set screw); 6 shanks on the 46Ã¢ÂÂ³ and 49Ã¢ÂÂ³; 7 shanks on the 53Ã¢ÂÂ³, 57Ã¢ÂÂ³, and 61Ã¢ÂÂ³.
Teeth are replaceable and interchangeable.
Installation is easy Ã¢ÂÂ no drilling required. Simply slide on and tighten set screws to 35-40 foot pounds using a 5/16Ã¢ÂÂ³ Allen wrench.
Works with standard material buckets with up to a 1/2Ã¢ÂÂ³ cutter bar.
Smooth design prevents mud and debris from hanging on.
How To Measure For A Toothbar:
Ã¢ÂÂ Measure the inside width of your bucket. This will determine what width you will need.
Ã¢ÂÂ¡ Measure the height of your cutting edge. This standard tooth bar will fit on a cutting edge of up to 1/2Ã¢ÂÂ³. If your cutting bar is 5/8Ã¢ÂÂ³-3/4Ã¢ÂÂ³, you will need ourÂ Heavy Duty Tooth Bar.